Catalogo Articoli (Spogli Riviste)

OPAC HELP

Titolo:
Development of structural composite products made from bamboo II: fundamental properties of laminated bamboo lumber
Autore:
Nugroho, N; Ando, N;
Indirizzi:
Univ Tokyo, Grad Sch Agr & Life Sci, Tokyo 1138657, Japan Univ Tokyo Tokyo Japan 1138657 Sch Agr & Life Sci, Tokyo 1138657, Japan
Titolo Testata:
JOURNAL OF WOOD SCIENCE
fascicolo: 3, volume: 47, anno: 2001,
pagine: 237 - 242
SICI:
1435-0211(2001)47:3<237:DOSCPM>2.0.ZU;2-2
Fonte:
ISI
Lingua:
ENG
Soggetto:
MECHANICAL-PROPERTIES;
Keywords:
laminated bamboo lumber; bamboo zephyr mat; pre-hot-pressed; bending properties;
Tipo documento:
Article
Natura:
Periodico
Settore Disciplinare:
Engineering, Computing & Technology
Citazioni:
16
Recensione:
Indirizzi per estratti:
Indirizzo: Nugroho, N Bogor Agr Univ, Fac Forestry, Dept Forest Prod Technol, Wood Engn Lab, POB168,Kampus Darmaga IPB, Bogor 16001, Indonesia Bogor Agr Univ POB 168,Kampus Darmaga IPB Bogor Indonesia 16001
Citazione:
N. Nugroho e N. Ando, "Development of structural composite products made from bamboo II: fundamental properties of laminated bamboo lumber", J WOOD SCI, 47(3), 2001, pp. 237-242

Abstract

This experiment explored the technical feasibility of using bamboo zephyr mat with pre-hot-pressed treatment for the manufacture of laminated bamboo lumber (LBL), which is similar in construction to that of laminated veneer lumber (LVL). Six LBL boards (made from four-ply bamboo zephyr mats) with approximate dimensions of 2 x 42 x 42 cm were fabricated using resorcinol-based adhesive. The experimental design involved three combinations of layered structures (types I, II, and III) and two LBL loading positions (H-beam and V-beam) during the bending test. These materials were then compared to ordinary LVL. Results indicated that the bending properties (moduli of rupture and elasticity) of LBL were comparable to those of LVL, but there was nosignificant effect on the physical and mechanical properties among the three types of LBL beam. Interestingly, orienting the glue line to the vertical direction (V-beam) could maximize the ultimate strength of the LBL.

ASDD Area Sistemi Dipartimentali e Documentali, Università di Bologna, Catalogo delle riviste ed altri periodici
Documento generato il 15/01/21 alle ore 22:20:46