Catalogo Articoli (Spogli Riviste)

OPAC HELP

Titolo:
A study of the effect of microcrack on the vibration mode shape
Autore:
Ravi, D; Liew, KM;
Indirizzi:
Nanyang Technol Univ, Sch Mech & Prod Engn, Singapore 639798, Singapore Nanyang Technol Univ Singapore Singapore 639798 gapore 639798, Singapore
Titolo Testata:
ENGINEERING STRUCTURES
fascicolo: 9, volume: 22, anno: 2000,
pagine: 1097 - 1102
SICI:
0141-0296(200009)22:9<1097:ASOTEO>2.0.ZU;2-8
Fonte:
ISI
Lingua:
ENG
Soggetto:
ACOUSTIC-EMISSION; FRACTURE;
Keywords:
defect; experiments; microcrack; mode shape; plastic deformation; vibration analysis;
Tipo documento:
Article
Natura:
Periodico
Settore Disciplinare:
Engineering, Computing & Technology
Citazioni:
24
Recensione:
Indirizzi per estratti:
Indirizzo: Liew, KM Nanyang Technol Univ, Sch Mech & Prod Engn, Nanyang Ave, Singapore 639798,Singapore Nanyang Technol Univ Nanyang Ave Singapore Singapore 639798 pore
Citazione:
D. Ravi e K.M. Liew, "A study of the effect of microcrack on the vibration mode shape", ENG STRUCT, 22(9), 2000, pp. 1097-1102

Abstract

This paper presents the modal analysis of an aluminum 6061 sheet in the presence of microcracks. Microcracks were introduced at the center of the sheet by compression loading and monitoring the deformation using the AcousticEmission Technique (AET). Modal analysis was conducted on the sheet under free boundary condition. The mode shapes were mapped using the vibration pattern imager (VPI) when the sheet was vibrated at the modal frequency. The overall mode shape did not provide any information regarding the elastic constraints introduced due to the presence of microcracks. Scans were made atdistances of 5 mm intervals on either side of the plastically deformed region on the plate in the horizontal and the vertical directions. It was found that by making line scans around the area of deformation the effect of microcracks on modal constraint could be detected. Using this information a map showing the constrained region surrounding the deformed region was plotted. The elastic constraints introduced on the modes due to the presence of microcracks were directional depending on the mode position. Frequency response analysis was performed around the deformed region. The second modal frequency measured at the edge of the sheet was very close to that of the first response frequency at the region near the deformed region. Metallurgicalanalysis and plastic material flow studies using an X-ray imager were madeon the deformed region. The direction of material flow correlates with thecurve generated for the elastic constrained area. (C) 2000 Elsevier Science Ltd. All rights reserved.

ASDD Area Sistemi Dipartimentali e Documentali, Università di Bologna, Catalogo delle riviste ed altri periodici
Documento generato il 16/07/20 alle ore 16:22:54