Catalogo Articoli (Spogli Riviste)

OPAC HELP

Titolo:
ELECTRICAL PERFORMANCE OF RTV SILICONE-RUBBER COATINGS
Autore:
GORUR RS; MISHRA J; TAY R; MCAFEE R;
Indirizzi:
ARIZONA STATE UNIV,DEPT ELECT ENGN TEMPE AZ 85287 WACKER SILICONES CORP ADRIAN MI 00000
Titolo Testata:
IEEE transactions on dielectrics and electrical insulation
fascicolo: 2, volume: 3, anno: 1996,
pagine: 299 - 306
SICI:
1070-9878(1996)3:2<299:EPORSC>2.0.ZU;2-3
Fonte:
ISI
Lingua:
ENG
Soggetto:
OUTDOOR INSULATION;
Tipo documento:
Article
Natura:
Periodico
Settore Disciplinare:
Science Citation Index Expanded
Citazioni:
11
Recensione:
Indirizzi per estratti:
Citazione:
R.S. Gorur et al., "ELECTRICAL PERFORMANCE OF RTV SILICONE-RUBBER COATINGS", IEEE transactions on dielectrics and electrical insulation, 3(2), 1996, pp. 299-306

Abstract

The role played by two major constituents in a room temperature vulcanized (RTV) silicone rubber coating, namely, the inorganic alumina trihydrate (ATH) filler and the silicone polymer, on the coating's electrical performance was examined. The principal variable in the RTV silicone rubber coatings evaluated was the different weight fraction of thesilicone polymer and ATH inorganic filler normally used for improvingthe tracking and erosion resistance. Other formulation details were essentially the same in the cured rubber. The coatings were spray coated on glazed porcelain rods and subjected to accelerated aging in a salt fog chamber. The changes produced by accelerated aging on the contamination withstand capability, leakage current suppression and erosion resistance were determined and correlated with the ratio of polymer toinorganic filler in the coating. It is shown that critical aspects ofelectrical performance necessary for satisfactory service operation such as contamination withstand capability before flashover and leakagecurrent suppression are superior for the coating with a relatively high ratio of polymer to inorganic filler in comparison to the coatings with a relatively low ratio of polymer to inorganic filler. While all the coatings showed a high erosion resistance under mild discharge activity, the erosion resistance was found to be superior for the formulations with high inorganic filler under conditions of intensive surfacedischarge activity.

ASDD Area Sistemi Dipartimentali e Documentali, Università di Bologna, Catalogo delle riviste ed altri periodici
Documento generato il 24/09/20 alle ore 19:57:16